FMI CGEF23B - Manual (Page 3)

www.fmiproducts.com 120926-26C 3
SAFETY
Continued
14. A heater has hot and arcing or sparking
parts inside. Do not use it in areas where
gasoline, paint or flammable liquids or
vapors are used or stored.
15. Use this heater only as described in this
manual. Any other use not recommended
by the manufacturer may cause fire, elec-
tric shock or injury to persons.
16. Avoid the use of an extension cord be-
cause the extension cord may overheat
and cause a risk of fire. However, if you
have to use an extension cord, the cord
should be No. 14 AWG minimum size and
rated not less than 1875 WATTS.
17. Always use ground fault protection where
required by electrical codes.
Description: 23" Fireplace/Insert
Voltage: 120
Watts: 1500
Amps: 15 Amp
Grounded Circuit
PRODUCT DIMENSIONS
Figure 1 - Heater Dimensions
Note: This heater must be electrically wired and
grounded in accordance with local codes or, in
the absence of local codes, with National Electric
Code ANSI/NFPA 70-latest edition or the Cana-
dian Electric Code, CSA C22.1 as appropriate.
19"
17"
8"
23"
18. Always disconnect power before perform-
ing any cleaning, maintenance or reloca-
tion of heater.
19. To prevent a possible fire, do not burn
wood or other materials in this heater.
20. To prevent electric shock or fire, always
use a certified electrician should new
circuits or outlets be required.
21. When transporting or storing heater, keep
in a dry place.
22. Control panel door gets hot during opera-
tion. Open door by pressing on right side.
A spring magnet will disengage. Pull door
down to open.
LISTING APPROVALS
This heater has been tested in accordance
with the CSA Standards for fixed and location-
dedicated electric room heaters in the United
States. All components are UL or CSA safety
certified.
If you need assistance during installation, please
contact your local dealer or the FMI PROD-
UCTS, LLC at 1-866-328-4537.
19"
17"
8"
23"