Follett E50CT400A - Manual (Page 13)

Installing Satellite-fill icemakers
(models C/E25CR400A/W, C/E50CR400A/W, C/E25HR400A/W, C/E50HR400A/W)
1. Install Satellite-fill icemaker following instructions in icemaker manual.
2. Run uninsulated ice transport tube from dispenser through ice transport tube knock-out (Fig. 5G) or through
counter opening to icemaker.
3. Insulate ice transport tube by sliding insulation over tube.
4. Adjust insulation to cover all exposed ice transport tubing including tubing inside dispenser cabinet.
5. Check that insulated ice transport tube runs continuously uphill (with no dips) from icemaker to dispenser.
6. Run bin signal wire from dispenser through utility knockout (Fig. 5F) or counter cutout to icemaker and
connect bin signal wire (two-conductor twist lock) to bin signal plug on icemaker.
7. Install appropriate plug on power cord and insert into wall socket.
8. Turn on dispenser water supply and check for leaks. Replace splash panel.
9. If dispenser is equipped with SensorSAFE remove protective plastic coating from dispenser lenses.
10. Remove top front cover by removing two screws at bottom corners of cover. Lift cover slightly and pull
forward. Turn on power and bin signal rocker switches. Replace front cover and secure with screws. Test
operation.
11. Clean and sanitize icemaker following instructions in icemaker manual. Discard sanitized ice.
12. Clean and sanitize dispenser hopper following instructions on page 16. Installation is complete.
13
See Icemaker Installation Manual (form #00124453) for critical installation instructions for
remote icemakers. Failure to comply with these instructions will result in poor performance
and void warranty.
!
engaging pin
5mm (.187) ice tube hole
ice hose mounting bracket
capillary tube
ice tube
26mm
(1.00")
Fig. 9 – Ice transport tube and ice level control stat mounting for freestanding dispensers and countertop
units with Satellite-fill icemaker