Follett E50CT400A - Manual (Page 23)

Ice transport tube replacement
models C/E25CT400A/W, C/E25HT400A/W,
C/E50CT400A/W, C/E50HT400A/W
Only use tubing supplied by Follett Corporation. !
Disassembly and replacement instructions
Dispense chute removal
1. Remove dispenser front cover.
2. Slide plastic dispense chute cover up and out to remove.
3. Pull out four white plastic fasteners and remove dispense chute.
Dispense wheel removal and installation
Note: Models with top mount icemakers require removal of icemaker before removing wheel.
1. Remove all ice from storage area of dispenser.
2. Remove center thumbnut from dispense wheel.
3. Remove thumbnuts holding baffle inside bin and remove baffle.
4. Tilt rear of wheel up and lift off motor drive shaft.
5. After reinstalling wheel, secure baffle loosely with thumbnuts, but do not tighten.
6. Place a 1/16" spacer against wheel and allow baffle to drop until it touches spacer.
7. Tighten thumbnuts and remove spacer.
Drive bar removal
1. Remove dispense wheel from dispenser (see above).
2. Pull drive bar out of its channel in bottom of wheel.
Wheel motor assembly removal
1. Shut water off; Remove front cover.
2. Remove dispense wheel and dispense chute covers (see
above).
3. Remove splash panel. Water line to solenoid valve can be disconnected from water inlet valve by pulling on
ring at end of inlet fitting.
4. Disconnect wiring to panel and set panel aside.
5. Disconnect wires on motor.
6. Remove four bolts (7/16" socket) holding motor assembly to bottom of dispenser.
7. Remove motor assembly.
side view wheel section
dispenser
front
baffle
1/16"
spacer
1
2
3
4
TIGHTEN
CLAMP
SCREW
23