Furuno FR-2125V User Manual

Page 52

Advertising
background image

4-11

2. Remove the right arm cover from the control head. Fasten the M-card base

assy. to the right arm cover as follows:

a) Fasten the ground wire with the M4X8 pan-head screw and the M4 teethed

locked washer as shown below.

b) Fasten the right arm cover to the card case with three M4X8 pan-head screws

(supplied).

Right arm cover

Pan-head screw
M4X8

Pan-head screw
M4X8 (3 pcs.)

Toothed lock
washer M4

M-card base assy.

Ground wire

Card slot

FRONT

Figure 4-9 Fastening the M-card base assy. to the right arm cover

3. Unfasten four M4X8 screws from the PCB card case cover from the display

pedestal.

4. Pass the connector from the M-card base assy. through the hole in the display

pedestal.

Display pedestal

PCB card
case cover

PCB card slot

Figure 4-10 Display pedestal

5. Set the RP Board (14P0298) in the top slot of the PCB card case.

Advertising