Furuno FR-2125V - Manual (Page 55)

4-14
6. Unfasten four M4X8 screws to remove the PCB card case cover at the front of
the display pedestal.
7. Set the RP Board (14P0298) in the top slot of the PCB card case.
8. Run the connector from the card case in front of the GYRO CONVERTER
Board as shown in Figure 4-14.
9. Plug the connector from the M-card base assy. in J1 on the RP Board as shown
in Figure 4-14.
INT Board
GYRO
CONVERTER
Board
FRONT
Fasten ground wire from connector to this screw.
RP connector
(TOP VIEW)
(FRONT VIEW)
RP Board
ARP Board
SPU Board
Route cable between ARP and SPU Boards.
J1
Figure 4-14 Display pedestal, front and top views
10.Fasten the ground wire from the connector at the location shown in Figure 4-
14.
11. Fasten the PCB card case cover to the display pedestal.
12.Close the monitor.