Fujitsu Siemens Computers Stylistic ST5112 - Manual (Page 20)

12
S t y l i s t i c S T 5 1 0 0 S e r i e s T a b l e t P C U s e r ’ s G u i d e – S e c t i o n O n e
Table 1-1. System Status Indicators
Battery • On State
• Idle Mode
Green, continuous Battery charge is between 50%-100%
Amber, continuous Battery charge is between 13%-49%
Red, continuous Battery charge is between 0%-12%
Red, blinking There is a battery error.
• Standby,
without AC
adapter
• Standby with AC
adapter
Green, blinking slow Battery charge is between 50%-100%.
Amber, blinking slow Battery charge is between 13%-49%.
Red, blinking slow Battery charge is between 0%-12%.
• Hibernate,
with AC adapter
• Off State
Off Battery is not installed, or system is off or in
Hibernate mode.
• Hibernate,
without AC
adapter
If battery is inserted during power off, LED
blinks amber for 4 seconds to detect
battery. Battery status is displayed for 5
seconds after that.
HDD Access • On State (or
flashing)
• Idle Mode
Green Displayed when hard disk drive is accessed.
• Standby
• Hibernate
• Off State
Off Hard disk drive is not being accessed.
Security • On State Green, continuous
(until password is
entered) The Security Indicator lights (if a password
was set) when the system resumes from
Off or Standby modes. You must enter the
password that was set in the Security Panel
before your system will resume operation.
(See Security Functions of Application Buttons
on page 17 for more information.)
In the following table, a “blinking” LED flashes at the rate of once per second; an LED that is “blinking, slow” flashes at the
rate of one second on, five seconds off.
Icon Mode/State LED State Remarks
Osian_UG.book Page 12 Tuesday, December 18, 2007 9:20 AM