Frymaster 1814E User Manual

Page 33

Advertising
background image

6-3

6.2.2 Filtration

Problems

Problem

Probable Causes

Corrective Action

Filter pump won't

start.

A. Power cord is not plugged in or

circuit breaker is tripped.

A. Verify that the power cord is

fully plugged in. If so, verify
that circuit breaker is not
tripped.

B. Pump motor has overheated

causing the thermal overload
switch to trip.

B. If the motor is too hot to touch

for more than a few seconds, the
thermal overload switch has
probably tripped. Allow the
motor to cool at least 45
minutes then press the Pump
Reset Switch.

C. Blockage in filter pump.

Test: Close the drain valve and
pull the filter pan out from the
fryer. Activate the pump. If the
pump motor hums for a short time
then stops, the probable cause is
blockage of the pump itself.

C. Pump blockages are usually

caused by sediment buildup in
the pump due to improperly
sized or installed filter paper
and failure to use the crumb
screen. Call a FAS.

Filter pump runs

but oil does not

return to frypot and

there is no bubbling

oil.

Blockage in filter pan suction tube.

Test: Close the drain valve and pull
the filter pan out from the fryer.
Activate the pump. If bubbling oil
occurs, there is a blockage in the
filter pan suction tube.

The blockage may be caused by
sediment buildup or, if solid
shortening is used, solidified
shortening in the tube. Use a thin,
flexible wire to remove the
blockage. If the blockage cannot
be removed, call a FAS.

Filter pump runs,

but oil return is very

slow and bubbling

oil occurs.

A. Improperly installed filter pan

components.

A. If using filter paper or pad

configuration, verify that filter
screen is in bottom of pan with
paper or pad on top of screen.

Verify that O-rings are present
and in good condition on filter
pan connection fitting.

If using Magnasol filter
assembly, verify that O-ring is
present and in good condition on
filter screen fitting.

B. Attempting to filter with oil that

is not hot enough.

B. See filter section on page 4-8.


6.2.3 Error

Messages

See chapter 2 in the controller manual.

Advertising