FUJITSU D1241 - Manual (Page 32)

28 User’s Manual
3. HARDWARE SETUP
14) IDE/SCSI Activity LED (2-pin IDELED) Also in Panel Connectors
This connector supplies power to the cabinet’s activity LED. Read and write
activity by devices connected to the Primary/Secondary IDE and SCSI connec-
tors will cause the LED to light up.
CUR-DLS IDE Activity LED
IDELED
CUR-DLS
R
+ -
*Same as the “HDD Access
LED” in the panel connectors
15) CPU and Chassis Fan Connectors (3-pin CPU_FAN1/2, CHA_FAN1/2)
These connectors support cooling fans of 350mA (4.2 Watts) or less. Orientate
the fans so that the heat sink fins allow airflow to go across the onboard heat
sink(s) instead of the expansion slots. Depending on the fan manufacturer, the
wiring and plug may be different. The red wire should be positive, while the
black should be ground. Connect the fan’s plug to the board taking into consid-
eration the polarity of the connector.
NOTE: The “Rotation” signal is to be used only by a specially designed fan with
rotation signal. The Rotations per Minute (RPM) can be monitored using Intel LDSM
Utility (provided with certain models).
WARNING! The CPU and/or motherboard will overheat if there is no airflow
across the CPU and onboard heatsinks. Damage may occur to the motherboard
and/or the CPU fan if these pins are incorrectly used. These are not jumpers,
do not place jumper caps over these pins.
CUR-DLS 12-Volt Cooling Fan Power
CHA_FAN1 / CPU_FAN2
CPU_FAN1 / CHA_FAN2
GND
Rotation
+12V
CUR-DLS
R
GND
Rotation
+12V
Connectors
3. H/W SETUP