FUJITSU D1241 - Manual (Page 33)

User’s Manual 29
3. HARDWARE SETUP
Connectors
3. H/W SETUP
The following PANEL illustration is used for items 17–26 (next page).
CUR-DLS System Panel Connectors
CUR-DLS
R
Chassis intrude
GND
SMI# buttton/sleep# button
NIC activity LED+
Power LED + HDD access LED
–
Status LED
–
Status LED+
RESET
button
GND
+5V HDD access LED+ Power LED
–
GND Speaker NIC activity LED
–
Power button
GND
1 10
11 20
NMI button
Pin Connector
1 & 12 NIC Activity LED
3 & 4 Status LED
4 & 5 SMI Lead
6 & 7* Power Button
7* & 8 Chassis Intrusion
9 & 10 Reset Switch
11 & 13 Power LED
15* & 16 NMI Button
17 & 20 Speaker
18 & 19 HDD Access LED
* Shared
Key
16) SMBus Connector (5-1 pin SMB)
This connector allows you to connect SMBus (System Management Bus) de-
vices. SMBus devices communicate by means of the SMBus with an SMBus
host and/or other SMBus devices. SMBus is a specific implementation of an I
2 C
bus, which is a multi-device bus; that is, multiple chips can be connected to the
same bus and each one can act as a master by initiating data transfer.
CUR-DLS SMBus Connector
CUR-DLS
R
1
SMB
SMBCLK
Ground
SMBDATA
+5V
17) NIC Activity LED (2-pin)
This shows the status of the NIC through a panel-mounted LED.
18) Status LED (2-pin)
This shows the system status as programmed through ASIC.
19) System Management Interrupt Lead (2-pin)
This allows the user to manually place the system into a suspend mode or “Green”
mode where system activity will be instantly decreased to save electricity and
expand the life of certain components when the system is not in use. This 2-pin
connector (see the preceding figure) connects to the case-mounted suspend switch.