FUJITSU D1241 - Manual (Page 41)

User’s Manual 37
4. BIOS SETUP
4. BIOS SETUP
6. When prompted to confirm the BIOS update, press Y to start the update.
7. The utility starts to program the new BIOS information into the flash
ROM. The boot block will be updated automatically only when neces-
sary. This will minimize the chance that a failed update will prevent
your system from booting up. When the programming is finished, Flashed
Successfully will be displayed.
Updating BIOS
NOTE: When you see the message “Boot Block is different”, you may
still press <Y> to update the BIOS. Yet if the update fails, your system
will run a greater risk of boot failure depending on whether the boot
block is damaged or not.