Frymaster BIRE14 - Manual (Page 28)

6-5
Problem Probable Causes Corrective Action
M2000 display
shows HI 2 BAD.
Computer in high-limit test mode.
This is displayed only during a test
of the high-limit circuit and indicates
that the high-limit has failed. DO
NOT OPERATE THE FRYER! Call
FASC.
M2000 display
shows PROBE
FAILURE with
alarm sounding.
Damaged computer wiring harness
or connector. Call FASC
M2000 display
shows IGN
Failure
with alarm
sounding. Heating
indicator is on, but
no heat.
Drain valve not fully closed. Press the ON/OFF switch off, close
the drain valve(s) completely, then
press the ON/OFF switch on.
A. Failed computer.
A. Call FASC.
M2000 display
shows
LOW TEMP,
heating indicator
cycles on and off
normally.
B. Damaged computer wiring
harness.
B. Call FASC.
M2000 display
shows IGN
failure and
alarm sounds, but
fryer operates
normally (false
alarm).
Failed computer.
Call FASC.
Computer will not
go into program
mode or some
buttons do not
actuate.
Failed computer.
Call FASC.
Heat indicator off
upon initial startup.
Display shows
or with alarm
sounding.
Failed computer.
Call FASC.