Furuno NX-700B - Manual (Page 47)

4-1
4. INSTALLATION
4.1 Display Unit
The display unit can be installed on a tabletop, on the overhead, or in a panel.
Refer to the outline drawings at the back of this manual for installation
instructions. When selecting a mounting location, keep in mind the following
points.
• Locate the unit away from exhaust pipes and vents.
• Locate it of direct sunlight, (or in a suitable, ventilated enclosure) to prevent
heat which can build up inside the cabinet.
• The mounting location should be well ventilated.
• Mount the unit where shock and vibration are minimal.
• Allow sufficient maintenance space at the sides and rear of the unit and leave
sufficient slack in cables, to facilitate maintenance and servicing.
• Compass safe distances are:
NX-700A (Standard: 1.45 m, Steering: 0.95 m)
NX-700B (Standard: 0.30 m, Steering: 0.30 m)
Tabletop, overhead mounting
1. Fix the hanger by using four self-tapping screws (5x20).
2. Screw knob bolts in display unit, set it to the hanger, and tighten the knob
bolts.
Note:
For the overhead mounting, reinforce the mounting location for the weight
of the display unit (NX-700A: 3.3 kg, NX-700B: 0.7 kg) and secure the
hanger, with bolts, nuts and washers (local supply).
NX-700A NX-700B