FRIGIDAIRE 137181900A - Manual (Page 7)

7
operatInG InStructIonS
Important
Clean the lint filter after every load.
2
Check that the lint filter is clean and in place.
 note
Over-drying can cause wrinkles, shrinkage, lint,
harshness and a build up of static electricity.
 note
If a setting is not available for the cycle selected, the
indicator will not light.
3
Load the dryer and close the door.
Load items loosely. The average wet load will •
fill the drum 1/3 to 1/2 full. Items need room to
tumble freely for even drying and less wrinkling.
If desired, place a dryer fabric softener sheet on •
top of the load at the beginning of the cycle.
To save energy and time and avoid uneven drying •
and wrinkling, do not overload the dryer.
When drying large items, dry only two or three •
items at a time. Fill out the load with small and
medium sized items.
For delicate or very small loads, add two or three •
similar items to improve tumbling action.
4 Select the appropriate cycle and settings for
each load.
A suitable drying temperature, dryness level and •
options will automatically be indicated for the cycle
selected. See the “Dryer Settings Chart” for more
details.
To change the drying temperature and dryness •
level, press the Temperature or Dryness buttons to
scroll to the desired settings.
To select or delete an option, press Options; then, •
while the indicator is blinking, press Select. The
indicator will light when the option has been se-
lected. It will no longer be lighted when the option
has been deleted.
Adjustments made to a cycle will be remembered •
and recalled each time that cycle is selected in the
future.
To return to factory settings, press the Start/Pause •
and Select buttons at the same time and hold until
the signal sounds.
Turn the cycle selector knob in either direction to •
select the cycle desired. The indicator for that cycle
will be illuminated.
The estimated drying time for Auto Dry cycles or •
the actual drying time for Timed Dry cycles will be
displayed.
operating your Dryer, continued
5 Start the cycle.
To add or remove items when the dryer is running, •
open the door. The dryer will stop when the door
is opened. Allow the drum to come to a complete
stop before reaching inside.
Close the door and press Start to resume the cycle. •
6
When the cycle ends, remove items immedi-
ately and hang or fold.
Press and hold both for ten seconds
to return to factory settings.