Freecom Technologies Network hard drive - Manual (Page 42)

Freecom Classic SL Network Drive
GB
11
42
3. My Classic SL Network Drive shows up as a Black Dot.
Please check the following: power cable is plugged in tightly, there is a
blinking LED where it is connected to (switch), and that any firewall/
antivirus software are disabled before installing. The latest versions of
antivirus software have script blocking.
Please ensure this feature is disabled before continuing.
You might also need to enable Classic SL Network Drive protocol and
programs to run. Even after you have done these steps, it is still possible that
the firewall/antivirus software will block access. If it still does notwork,
uninstall the firewall/antivirus software, reboot, and reinstall our software.
If it succeeds, then you can re-install the antivirus/firewall software after-
wards.
If using Wireless connection, please make sure that you are connected to the
wireless router and that you have a strong signal. Try going to your wireless
router’s website to check for the latest firmware and also check for the latest
drivers for your wireless card.
4. I have installed drivers for Windows 98SE and keep getting discon-
nected when transferring large files.
Windows 98SE can only read FAT32 file systems. Unfortunately, FAT32
comes with a limitation on single large files transfers up to 4GB. This is a file
system limitation. Please also check our website for updates on the Win98SE
drivers.
5. I have just installed Classic SL Network Drive, why does Classic SL
Network Drive show up as a red color?
Try unplugging your Classic SL Network Drive’s power cord, wait about 10
seconds, and plug it back in. If this doesn’t work, try restarting your
computer as well.
6. When adding Classic SL Network Drive to my computer, why does
the "ADD" button stay gray?
You may not have entered all the alpha-numeric values correctly. There are
no letter "O"s; please verify that you have used the number "0" (zero) for
anything resembling an "O." Also, check your other letters as well; two V’s
may look like a W. Start by entering only the Classic SL Network Drive ID. The
ADD button should not be greyed out if the correct ID is entered. Once it is
not grayed out, proceed to add the Write Key as well if you want read-write
access. Also make sure that there are 20 characters for the Classic SL Network
Drive ID, not including the Write Key.