Freecom Technologies Network hard drive - Manual (Page 46)

Freecom Classic SL Network Drive
GB
12
46
Try setting your NIC’s speed/duplex settings to 100Mb/full duplex. Right click
on My Network Places- click on Properties- right click on Local Area
Connection and click on Properties. Then click on the Configure button next
to your NIC- and click on the Advanced tab. There, you should be able to find
something related to "Speed & Duplex", "Media Settings", etc . where, once
highlighted, you can click on a drop down menu and select 100Mb/full
duplex.
You can try going to your NIC (Ethernet card) manufacturer and downloading
the latest drivers.
If using a DSL router, please try updating the firmware on it as well. Also, try
plugging Classic SL Network Drive your PC into a different port on the switch
and see if you have different results.
7. I have installed the Classic SL Network Drive key but cannot see
Classic SL Network Drive in "My Computer." What should I do?
Open up "Computer Management" by right-clicking on "My Computer."
Go to "Manage," then click on "Disk Management." Check to see if your
Classic SL Network Drive is recognized. It should show up as Disk 1 or Disk 2
or a different number depending on the number of drives that you have on
your computer.
Right -click on the appropriate "Disk #" and click "Initialize.". Also, for
Windows 98SE / Windows ME / Mac users, you will need to format disk to
FAT32 for it to be recognized.
8. I’ve just installed Classic SL Network Drive software, and now my
internet does not work.
This can happen when used with McAfee Virus Scan Professional 7.0; you
must disable HAWK Script Stopper in McAfee, before installing our soft-
ware.
9. I have clicked on the Classic SL Network Drive Administrator Tool on
my desktop and nothing happens.
The icon on the desktop is only used to launch "Classic SL Network Drive
Administrator Tool" into the system tray, if for some reason it is not in there
already. The icon in the system tray is used for enabling, disabling, adding,
removing and switching Read / Write modes on Classic SL Network Drive.
10. I am getting a "Data has been corrupted" message on my computer
when I try to open up or copy a file. What should I do?
Open up Command Prompt and run "chkdsk" for the Classic SL Network
Drive drive. To do this Go to Start -> Run-> type in "cmd" without the
quotation marks. Then type in "chkdsk Classic SL Network Drive Drive Letter:
/F" For example, if your Classic SL Network Drive shows up as drive letter E:
in My Computer, you would type in the following: chkdsk E: /F