Figure 1-23 mode selection – FUJITSU CAN-Motor Board MB91F267N User Manual
Page 33
Advertising
AN07-00180-3E
- 33 -
1.1.5
Configuring the evaluation board and connecting it to the PC
After SOFTUNE installation, configure a switch on the board and then connect it to the PC.
Set the “MODE” selector on the board to “
PRG
”.
Figure 1-23 MODE selection
MODE selector
Operation
PRG
FLASH memory serial write mode
→Used to write a program into the microcontroller.
RUN
Single ship mode
→Used to run the program written into it.
Make sure that the MODE selector is set to “
PRG
”.
Then, connect it to the PC.
Set the MODE selector to
“
PRG
”.
Advertising