FUJITSU CAN-Motor Board MB91F267N - Manual (Page 36)

AN07-00180-3E
- 36 -
2.1 Executing in single chip mode
In single chip mode, take the following procedures.
(1) Building a project
(2) Writing the program into the microcontroller
2.1.1 Building a project
Preparation
Extract the following file from the inside of the folder extracted by “1.1.1 Downloading the software”.
¥sample programs¥ bitpot_red_SampleProgram.zip
Select “Start” → “All Programs” → “Softune V6” → “FR Family Softune Workbench” to activate
SOFTUNE.
As shown in “Figure 2-1 Opening a workspace”, select the menu of SOFTUNE, “File” and then “Open
Workspace” to open a workspace.
Figure 2-1 Opening a workspace