Furuno Sc 50 - Manual (Page 3)

i
SAFETY INSTRUCTIONS
WARNING WARNING
Turn off the power at the switchboard
before beginning the installation.
Fire or electrical shock can result if the
power is left on.
Do not install the equipment where it
may get wet from rain or water splash.
Water in the equipment can cause fire,
electrical shock or damage to the equipment.
NOTICE NOTICE
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
Safety Instructions for the Operator Safety Instructions for the Installer
Standard
Compass Steering
Compass
Display unit
SC-502
0.4 m 0.3 m
Processor unit
SC-501
0.9 m 0.6 m
Antenna unit
SC-303
0.3 m 0.3 m
Antenna unit
SC-603
0.3 m 0.3 m
WARNING
To avoid electrical shock, do not
remove cover. No user-serviceable
parts inside.
WARNING LABEL
A warning label is attached to the
processor unit. Do not remove the label.
If the label is missing or damaged,
contact a FURUNO agent or dealer
about replacement.
WARNING LABEL
Name:
Warning Label (1)
Type: 86-003-1011-1
Code No.: 100-236-231
WARNING WARNING
Do not disassemble or modify the
equipment.
Fire, electrical shock or serious injury can
result.
Immediately turn off the power at the
switchboard if the equipment is emitting
smoke or fire.
Continued use can cause fatal damage to
the equipment. Contact a FURUNO agent
for service.
Do not place liquid-filled containers on
the top of the processor unit.
Fire or electrical shock may result if the
liquid enters the equipment.
Use the proper fuse.
Use of a wrong fuse can damage the
equipment and cause fire.
CAUTION CAUTION
No one navigation device should ever
be solely replied upon for the navigation
of a vessel.
Always confirm position against all avail-
able aids to navigation (incl. nautical charts),
for safety of vessel and crew.
ELECTRICAL SHOCK HAZARD
Do not open the equipment.
Only qualified personnel
should work inside the
equipment.