FUJITSU Embedded MegaRAID SATA CA97232-0014-01EN - Manual (Page 8)

Supplement for Embedded MegaRAID SATA User ’s Guide
Step 6 Once the system is up and running, create and configure a Windows user
account.
Regarding the above, the description is change as follows;
Current User’s Guide: (ServerView RAID V2.x.xx-x or previous)
Users Account for User Privileges
1. Create a user account for the User privileges of ServerView RAID.
Make sure that the user account for the User privileges does not belong to the “raid-adm”
group.
ServerView RAID V3.x.xx-x or later:
User Account for User Privileges
1. Create a user account for the User privileges of ServerView RAID.
2. Create “raid-usr” group.
3. Set the user account for the user privileges to be included in the “raid-usr” group.
Make sure that the user account for the user privileges does not belong to the “raid-adm”
group.
¾ “4.3.2 How to Uninstall ServerView RAID” (page 66)
Follow the instruction shown below to uninstall ServerView RAID when ServerCore is installed with
Windows Server 2008.
1. Log on to Windows with Administrator privileges.
2. Execute the following command from the command prompt.
wmic product where name=”ServerView RAID Manager” call uninstall
3. Restart the system.
¾ “4.4.1 Installing HDD Check Scheduler” (page 68)
When in ServerCore installation with Windows Server 2008, The instruction in “4.1.1 Installing HDD
Check Scheduler” on page 68 is partially changed as follows;
Step 3
Click [Start] button – [Run...]. Type the following file name and click [OK].
As for the script above, the “start” menu” is not available when in ServerCore installation with
Windows Server 2008. input the command as follows;
[CD/DVD drive]:
cd \RAIDTOOL\HDDCS\Windows
install.bat
¾ “4.4.2 Modifying HDD Check Start Time” (page 69)
The instruction in “4.4.2 Modifying HDD Check Start Time” on page 69 is partially changed as
follows;
Step 2
Click [Start] button – [All Programs] (or [Programs]) – [Accessories] – [Command
Prompt].
The above procedure is not needed when ServerCore is installed with Windows Server 2008.
Step 4 Write down the [ID] value for the row with the following value in the [Command Line]
column:
and Step 6 Register a new schedule. By using the AT command,…:
Regarding the above procedure, follow the same procedure as Windows Server 2003 when
in Windows Server 2008. Refer to the instruction of Windows Server 2003 for the operation.
8 / 13