Installing a hot-plug power supply unit (psu), Required tools, Starting the task – FUJITSU PRIMERGY RX900 S1 User Manual
Page 54: Removing a dummy module (if applicable), 1 installing a hot-plug power supply unit (psu), 1 required tools, 2 starting the task, 3 removing a dummy module (if applicable)
Advertising
54
Maintenance Manual
RX900
S1
Power supply
5.1
Installing a hot-plug Power Supply Unit
(PSU)
5.1.1
Required tools
●
Starting and completing the task:
–
key for the rack doors (if applicable)
●
Installing the power supply unit: tool-less
5.1.2
Starting the task
Ê
Perform the following procedures:
1. Open the rear door of the rack, see
"Opening the rack door" on page 40
5.1.3
Removing a dummy module (if applicable)
I
Dummy modules protect free bays against environmental impact.
Remove the dummy module before installing an additional power supply
unit.
Figure 11: Removing a dummy module from a PSU bay
Trained personnel
Advertising