Freecom Technologies FSG-3 - Manual (Page 53)

GB
6
53
6.5.3 WAN Options
These are options for experts. Only change them if you know what you are
doing!
Options Description
MTU (for DSL only) MTU settings (MTU = Maximum Transfer Unit)
(In Bytes)
Answer ICMP packets This will allow others to ping the host. It is good for
(ping etc)
debugging but it can be asecurity hazard!
Enable exposed host Enabling this will allow one PC on the LAN to act as if it
bypasses the firewall completely and has a direct con-
nection to the internet (Attention: An exposed host is
computer that virtually has a direct connection to the
internet. This is a big security risk, not only to this
computer but to the whole LAN!).
IP address Exposed host IP address.
Enable hardware This will enable you to set the MAC address of the WAN
address cloning connection so it matches the address your ISP authenti-
cates by.
MAC address This is the MAC address your WAN port will be cloned to.
Open SBM/CIFS on This will open SMB/CIFS for the WAN port. Only needs to
WAN port be enabled when the FSG-3 is used behind a router.
Configuration options explained