FUJITSU 50FH5037E-02 - Manual (Page 65)

Operation error occurs when the values of X
1
+ X
2
[(#10, #11) + (#12, #13)] and
Y
1
+ Y
2
[(#14, #15) + (#16, #17)] are more than the values shown below.
X
1
+ X
2
Y
1
+ Y
2
4864 6912
These values must be specified in binary in units of 1/400 inch.
Notes:
1. When the picking is specified, only a specified area of the document is read.
However, when the ADF is used, and the document length is shorter than
the specified area, read operation is stopped at the edge of document.
2. When the specified area is larger than the double letter size, read area
specification error occurs.
3. When the jam detection bit (control register #2) is ™1∫, a setting of Y2 is
ignored.
50FH5037E>02 6 $ 15