FUJITSU 50FH5037E-02 - Manual (Page 33)

3.5 Operator Panel
Figure 3.4 shows the operator panel and Tables 3.1 and 3.2 list the button and lamp
names and functions.
Figure 3.4 M3097E operator panel
Ready
Check
Power
Liquid crystal display
24 columns ¥ 2 rows
Mode 1
Mode 1
ADF Size Density Resolution Stop
Landscape Halftone Document Start
Table 3.1 Button names and functions
Switch name Function
Start Press this button to start the read operation. In manual mode,
when the ready lamp is lit.
Stop If this button is pressed during a read operation, the following
results occur:
For a flatbed: Interrupts the read operation immediately, and
returns the carrier to the home position.
For an automatic feeder: Interrupts a read operation immediately,
and ejects the paper being fed. Paper
that has already been picked, but from
which data has not been read yet, is
ejected without being read.
Press this button after removing jammed paper to release the jam
state and enables read operation.
Resolution Specifies the read resolution. The read resolution is displayed on
the LCD.
Document Specifies the documents from which data is read.
Halftone Specifies whether to perform halftone processing (dithering or error
diffusion). Also, specifies the automatic separation (dithering or
error diffusion) if an image processing ¬ option is present.
Density Specifies the read density.
Size Specifies the paper size.
ADF Specifies whether to read data from documents by using the
automatic document feeder or the flatbed.
Landscape Specifies whether to read data from documents in portrait or
landscape mode (read direction).
Mode 1 Will be described later.
Mode 2 Will be described later.
50FH5037E>02 3 $ 7