FMI MF42ONE - Manual (Page 13)

www.fmiproducts.com 125636-01A 13
INSTALLATION
Continued
Find the middle split log (LMF42-SC: D-021 or LMF48-SC: 5.
D028). See Figures 21 and 21A. The split side of the log
faces forward. The log has a notch that fits around the
burner tube on the right side. The left side of the burner tube
fits into the notch on the back side of this log. The log is
placed properly when it sits parallel to the tube burner and
the square peg is pointing up. See figures for reference.
Figure 20A - Installing Charred Log Top View
Figure 20B - Installing Charred Log Top Side View
Figure 21 - Installing Middle Split Log (D-021)
Middle Split Log
(D-021 or D028)
Square Peg
Square Grate Log Notch
Figure 23 - Installing Front Top Log
Front Top Log
(D-024)
Rectangular
Peg
Right Split
Crossover
Log (D-022)
Middle Split Log
Figure 21A - Installing Middle Split Log Rear Top Side
View
Figure 22 - Installing Right Split Crossover Log
Log Notch Burner Tube
Find the front top log (D-024). See Figure 23. The left end 7.
of this log has a square hole that fits over a square peg that
is on the top of the middle split log. The right end of this log
rests behind the knot on the top of the front right log.
Find the right split crossover log (D-022) The bottom of 6.
the log has a rectangular stand off that fits in the slots on
the right side of the front right log and the middle split log.
Place this log as shown in Figure 22.
Right Split Crossover
Log (D-022)
Right Front Log
Square Peg