FMC Corporation - Talstar FMC L06 - Manual (Page 28)

Doc No: OMM50000903
Rev: B Page 28 of 65
Subject to contractual terms and conditions to the contrary, this document and all the information contained herein are the confidential and exclusive
property of FMC Technologies, and may not be reproduced, disclosed, or made public in any manner prior to express written authorization by FMC.
7. Always replace the cylinder
gaskets (48) when the cylinders
have been moved or replaced.
8. Installation will be the reverse of this procedure.
9. Torque all fasteners as outlined in the Fastener Torque Requirements, Section
11.0 of this manual. Please note that if the nuts (61) on the fluid cylinder studs
(59) are not properly torqued, a failure is likely.