Fishman AIRFREE LDS9000 - Manual (Page 28)

28
Glossary
FOOT .................................Setting for using a foot pedal to activate dispensing cycle
HAND ................................Setting for using finger switch to activate a dispense cycle
SYR.....................................Syringe— barrel reservoir selection
DIA.....................................Length—user-defined syringe inside length from ears to bottom in
millimeters
V .........................................Volume—Volume to be dispensed, in cubic centimeters
R .........................................Dispense Rate—The rate, in cubic centimeters per second, at
which you want to dispense the fluid
PRGM.................................Program key to enter or exit at AUTO DISPENSE PROGRAM
MANAGER
ENTER ...............................Key to activate desired parameter
NEXT .................................Key to advance to the next screen without changing the exiting
parameters
SYRINGE
ATTACHMENT .................The ideal position for the ears of the barrel reservoir after locking
it into place, is flush up against the retaining plate. Note: Always
attach a new barrel reservoir with the tip cap on.
PRIMING
THE SYSTEM ...................Eliminates any trapped air between the barrel reservoir and
needle. Always prime the system at start up.
PARAMETER
LIMITS ...............................If you want to know the min., max, or high and low values of
parameters for a given syringe, type in 999 at the prompt and
press the ENTER key. View the display; it will flash the values
on the screen and then return.
RETRACT ..........................When you are in program mode and you change the
EXTEND/RETRACT switch to RETRACT, the system will
prompt you to hit the ENTER key or flip the switch back to
EXTEND. This is a safety precaution. If you retract with the
PosiLok
TM piston attached, the barrel reservoir will fill up with air
from the open end. Before you use the retract feature, be sure
you remove your barrel reservoir. When retracting the lead screw
in manual mode, all you have to do is flip the
EXTEND/RETRACT switch to RETRACT. The PosiLok
TM
piston will retract for as long as the foot pedal is depressed.