Fishman AIRFREE LDS9000 - Manual (Page 29)

29
Glossary
DISPENSE RATE ...............Always start with the slowest recommended rate and increase
incrementally.
DRAWBACK DELAY .........When using a small needle you can take advantage of the
drawback delay feature to give you more control over your output
volume. This feature allows the fluid to flow out of the syringe
before you drawback the PosiLok
TM piston and begin your next
dispense cycle.
FACTORY SETTINGS .......The factory settings will be replaced with your settings when you
save into location #1 and #2
SAVE ...................................When you save an application into a location that has a
previously stored application, you will be asked to replace the
existing application.
RESTORE ...........................When you restore an application from a location, the parameters
will flash on the display. You will then be asked to restore the
application.
ACTIVATING
A PARAMETER..................if you notice that a parameter that you set didn’t take effect,
make sure you pressed the ENTER key before proceeding to the
next screen. If you did not press the ENTER key, the values you
entered will not take effect on the next dispensing cycle.
NEEDLE SELECTION ..... When selecting a needle we recommend using the FreeFlow TM tip
with the LDS9000. This tip allows the least amount of flow
restriction thus allowing positive flow of the fluid from the
syringe.
PREPACKAGED
SYRINGE ..........................Must be free of air pockets to receive the full benefits of the
LDS9000. Contact your Fishman representative for AirFree TM
filling suggestions.