Freedom9 IP 100 - Manual (Page 62)

be used if the Primary DNS Server cannot be contacted.
Remote Console and HTTPS port: Port number which the device’s Remote Console server
and HTTPS server are listening on. If left empty the default value will be used.
HTTP port: Port number which the device’s HTTP server is listening on. If left empty the default
value will be used.
Telnet port: Port number which the device’s Telnet server is listening on. If left empty the default
value will be used.
Bandwidth limitation: The maximum network traffic generated by the device. Value in kbit/s.
Enable Telnet access: Select this option to allow access to the freeView IP 100 using the Telnet
Gateway see Section 6.5.5 for more details.
Disable Setup Protocol: Enable this option to exclude the freeView IP 100 from the setup
protocol.
6.5.2 Dynamic DNS
Figure 6-26: Dynamic DNS
A freely available Dynamic DNS service (e.g. dyndns.org) can be used in the scenario shown in
Figure 6-27:
60