Freedom9 IP 100 - Manual (Page 8)

1.4 Initial IP Configuration
By default, the freeView IP 100 uses the network parameters shown in Table 1-1.
Parameter Value
IP auto configuration Static
IP-Address 192.168.1.22
Net-mask 255.255.255.0
Default-Gateway None
Table 1-1: Default network configuration
If these network parameters do not match the network configuration, the device's network
settings can be configured using the program KVMSetup.exe located on the installation CD after
the unit has been connected to the network and powered on.
To change the network settings of the device:
1. Open Windows Explorer and browse to the CD drive.
2. Double-click the file KVMSetup.exe.
3. A screen similar to Figure 1-2 will be displayed.
Figure 1-2: KVM Setup Program
4. Select the unit’s MAC address from the drop-down list under “Device MAC address”.
5. Enter the desired IP address for the device under “Network Configuration”.
6