Foundry Networks M2404F - Manual (Page 34)

Foundry NetIron M2404C/M2404F Metro Access Switches
January 2007 © 2007 Foundry Networks, Inc. 28
6. Configure the switch to boot with the newly downloaded image. This is done by
selecting boot application and boot device.
device-name#config boot-param
device-name(boot param)#application <local application filename>
device-name(boot param)#device local
device-name(boot param)#exit
Example:
device-name#config boot
device-name(boot param)#application M2404v2.0.bin
device-name(boot param)#device local
device-name(boot param)#exit
7. Reset the switch using one of the reload commands. Note that, if you are connected
to the switch through Telnet, your Telnet session will be disconnected.
Select from the following reload commands:
1. reload save - this command updates the device's startup configuration to
match the running configuration and reboots the switch.
2. reload to-defaults – this command resets the device's startup configuration
to match the factory defaults and reboots the switch.
After the execution of the command, confirmation is required [y/n]. Enter “y” to
confirm the command.
Example with “reload” command:
device-name#reload save
Save current configuration and reboot the Switch ?
[y/n] : y
...
Example with “reload to-defaults” command:
device-name#reload to-defaults
Restore factory setting and reboot the Switch ?
[y/n] : y
...
8. After the switch reboots, use the show version command to check the version.
Downloading a NI-M2404WebView Image Using TFTP
To download a NI-M2404WebView software image to the switch from a TFTP server, proceed
as follows: