Config system pstn, Syntax – Fortinet FortiGate Voice 4.0 MR1 User Manual
Page 57
FortiGate Voice VoIP, PBX, and PSTN CLI Reference
config system pstn
FortiGate Voice Version 4.0 MR1 Administration Guide
01-410-112851-20100601
57
config system pstn
Use this command to configure the PSTN interfaces. PSTN interfaces are available on
some FortiGate Voice models.
Syntax
config system pstn
set
set
set
set
user-callerid {enable | disable}
set
cid-signalling {bell | dtmf | v23 | v23-jp}
set
set
set
set
set
set
set
set
set
end
Variables
Description
Default
edit <fxo_name>
Enter the name of the FXO.
No
default
cid-name
<caller_name>
This name is used for caller ID for calls from the FortiGate
Voice unit to the PSTN. It can be any name, such as a
company name, that identifies the branch office.
No
default
cid-number
<caller_name>
Enter the phone number of the PSTN phone line as
provided by your phone service provider.
No
default
status
{enable | disable}
Enable the status of the port.
No
default
user-callerid
{enable | disable}
Enable to catch the caller ID.
No
default
cid-signalling {bell
| dtmf | v23 |
v23-jp}
Enter the caller ID protocol. The protocol v23-jp is the v23
protocol for Japan.
No
default
cid-start
{polarity | ring}
Enter to start transmitting the caller ID.
No
default
send-callerid-after
<integer>
Enter a number for the number of rings after that the caller
ID began to transmit.
No
default
hangup-on-polarity-
reversal
Enter to have the phone hang up when there is polarity
reversal.
No
default
hangup-on-zero-
voltage
Enter to have the phone hang up when there is zero
voltage.
No
default
hangup-on-busy-tone
Enter to have the phone hang up when a busy tone is
detected.
No
default
busycount <integer>
Enter a number for the accurate number of busy tones that
are detected.
No
default