Furuno FM-8800D/8800S - Manual (Page 20)

1. OPERATIONAL OVERVIEW
1-6
Below are the indications which appear on the standby display on the remote
handset.
INTL
Hi
Rx SCAN
DUP
03
SHIFT
MANUAL ACK** 3*
GPS ERROR
LAT: 12 34' N
LON: 123 45' E
12:34 UTC
AUTO
WATCH CH70**
If you press at the left-hand screen, right-hand screen appears.
If you press at the right-hand screen, the left-hand screen appears
immediately.
The indications are the same as those on of the transceiver unit.
The *- marked number is the terminal number of the remote station.
**: If no MMSI is registered, the message “DSC UNAVAIL” appears instead of
MANUAL ACK and WATCH CH70. “DISTRESS MODE” is displayed at
distress calling.
Note: The screen of the remote handset is smaller than the one of the
transceiver unit. In this manual, display examples are from the transceiver
unit. In the remote handset, scrolling with up or down arrow key displays
same information as the screen of the transceiver unit.
Remote handset does not have a channel knob, but the transceiver unit
does. To set private channel or memory channel at the remote station,
use [2] key or [8] key.
1.1.4 Audio alarms
When you receive a distress alert or other DSC call, the audible and visual
alarms are released. For the distress or urgency call, the audio alarm sounds
until the CANCEL key is pressed. For all other calls, the audible alarm sounds
for two minutes and the automatically goes off. The tone of the alarm changes
with the call received. By becoming accustomed to the tone, you can know
which type of call you have received.