Friedrich MW12C1H - Manual (Page 11)

Pressing CLOCK button, blinks. Within 5 seconds , pressing + or - button adjusts the
present time. Holding down either button above 2 seconds increases or decreases the
CLOCK :
time by 1 minute every 0.5 second and then by 10 minutes every 0.5 second. During
blinking after setting, press CLOCK button again to confirm the setting, and then
will be constantly displayed.
7
Remote Controller Description
:
This button is used for setting Fan Speed in the sequence that goes from AUTO,
to then back to Auto.
,
, ,
FAN :
6
MODE : 5
Each time you press this button, a mode is selected in a sequence that goes from AUTO,
COOL,DRY, FAN,and HEAT
* , as the following:
AUTO COOL DRY FAN HEAT
*
*Note: Only for models with heating function.
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not
be displayed on the LCD, and the unit will automatically select the suitable operation
mode in accordance with the room temperature to make indoor room comfortable.
1
3
2
4
Press this button to turn on the unit .Press this button again to turn off the unit.
Press this button to decrease set temperature . Hold it down for above 2 seconds to
rapidly decrease set temperature. In AUTO mode, set temperature is not adjustable.
Press this button to increase set temperature. Hold it down for above 2 seconds to
rapidly increase set temperature. In AUTO mode, set temperature is not adjustable.
Auto
Low speed Medium speed High speed
Remote Control Instructions
SENSOR :
SENSOR according to the sensed temperature. Press this button again to cancel function.
START / STOP :
AUTO
7
Press this button to turn on function. The unit automatically adjust temperature SENSOR