Friedrich MW12C1H - Manual (Page 13)

★
●
●
●
●
●
1.Remove the battery cover plate from the rear of the remote controller.
(As shown in the figure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Reinstall the battery cover plate.
When replacing the batteries, do not use old or different types of batteries,
If the remote controller will not be used for a long time, please
otherwise, it may cause malfunction.
remove batteries to prevent batteries from leaking.
The operation should be performed in its receiving range.
If the remote controller does not operate normally, please take the
batteries out and reinsert them after 30 seconds. If it still can't operate properly,
Notes:
replace the batteries.
Sketch map for
replacing batteries
Replacement of Batteries
Press "+ " and "-" buttons simultaneously to lock or unlock the keypad. If the remote
controller is locked, is
pressing any button, blinks
three times.
℃ ℉
SLEEP:
LIGHT:
16
Press this button to go into the SLEEP operation mode. Press it again to cancel this
Press LIGHT button to turn on the display's light and press this button again to turn off
disappears.
Combination of "+" and "-" buttons: About lock
14
15
or DRY mode to maintain the most
comfortable temperature for you.
Remote Control Instructions
17 Combination of "MODE" and "-" buttons:
, press
"
MODE
"
displayed. In this case,
Allows you to toggle between Fahrenheit and Celsius.
When the unit is OFF and " - " buttons simultaneously to switch between and .
3 feet It should be kept away from the TV set or stereo sound sets.
9
the display's light. If the light is turned on, is displayed. If the light is tunrned off,
function. This function is available in COOL