FUJITSU Eturneus Disk Storage System (ISCSI) for VMware ESX User Manual
Page 24
5
Confirm that the [Enabled] checkbox is selected under "Status" on the [General] tab and click [Config-
ure] again.
6
Confirm that the iSCSI name is displayed in the "iSCSI Name" column and click the [Cancel] button.
7
Select the [Dynamic Discovery] tab and click the [Add] button.
8
Enter the IP address for the iSCSI port of the connected ETERNUS DX Disk storage system as the iSCSI
server IP address, confirm that the port is set to "Port 3260" (default), and click the [OK] button.
9
Confirm that the IP address for the iSCSI port of the ETERNUS DX Disk storage system is displayed as
follows.
10
If the connected ETERNUS DX Disk storage system uses multiple iSCSI ports, repeat the IP address addi-
tion process for each iSCSI port. (Repeat
.)
Chapter 6 Setting Up the VMware ESX Server
6.1 For VMware vSphere
24
ETERNUS DX Disk storage systems User's Guide -Server Connection-(iSCSI) for VMware
®
ESX
Copyright 2013 FUJITSU LIMITED
P3AM-3412-13ENZ0