Furuno 1763C - Manual (Page 200)

5. CUSTOMIZING YOUR UNIT
5-28
5. Press the ENTER soft key to register your selection.
6. If necessary, you may enter a position offset to refine Loran C position
accuracy. Select (GRI) CORRECTION 1 or CORRECTION 2 and press the
EDIT soft key. Enter correction value with the cursor pad and [ENTER] knob
and then press the ENTER soft key or the [ENTER] knob. Use the +
<− −> -
soft key to switch from plus to minus and vice versa.
7. Press the RETURN soft key twice.
8. Press the GENERAL SETUP soft key.
9. Press the NEXT PAGE soft key.
10.Select “LORAN C” from “TD DISPLAY”, “TD” from “POSITION DISPLAY” and
press the ENTER soft key.
11. Press the RETURN soft key followed by the [MENU] key to close the menu.
Displaying DECCA TDs
1. Select CHAIN and press the EDIT soft key to show the chain & station pair
window.
CHAIN STATION PAIR
S BALTIC
01 R-G
▲
▼
▼
Decca chain and station pair window
2. Use ▲ or ▼ on the cursor pad to select Decca chain number.
3. Press ► to enable selection of lane.
CHAIN STATION PAIR
S BALTIC
R-G 01
▲
▼
▼
4. Use ▲ or ▼ on the cursor pad to select lane pair (R: red, G: green and P:
purple).
5. Press the ENTER soft key to register your selection.
6. If necessary, you may enter position offset to refine Decca position. Select
(CHAIN) CORRECTION 1 or CORRECTION 2 and press the EDIT soft key.
Enter correction value with the cursor pad and [ENTER] knob and then press
the ENTER soft key or the [ENTER] knob. Use the +
<− −> - soft key to switch
from plus to minus and vice versa.
7. Press the RETURN soft key twice.
8. Press the GENERAL SETUP soft key followed by the NEXT PAGE soft key.
10. Select “DECCA” from “TD DISPLAY”, “TD” from “POSITION DISPLAY” and
press the ENTER soft key.
11. Press the RETURN soft key followed by the [MENU] key to close the menu.