Furuno 1942 MARK-2 - Manual (Page 21)

3-1
3.2 Selecting the Presentation
Mode
With heading sensor connection, this radar
provides four presentation modes: head-up,
course-up, north-up and true motion.
1. Press the [MENU] key.
2. Operate the omnipad to select “MODE.”
3. Press the [ACQ/ENTER] key.
The display and the display mode indication
at the top left-hand corner of the display
change in the sequence of HU (heading up),
CU (course up), NU (north up) and TM (true
motion) when the [ACQ/ENTER] key is
pressed. If there is no heading sensor con-
nection, the display mode is always HU.
4. Press the [MENU] key to close the menu.
Note: The radar begins operation with last
selected display mode (except course up)
whenever the unit is turned on. Note how-
ever that head up is selected when course
up was the last used mode.
Head up
The picture is oriented so the heading marker
is at the top of the display. This mode is use-
ful for navigation in congested waters.
Course up
The course up mode shows ship’ s heading
by the heading marker, at the top of the dis-
play. To get heading desired, steer vessel in
direction desired, and then show “CU” at the
top left-hand corner of the display.
3.1 Basic Menu Operation
The menu mostly contains less-often used
functions which once preset do not require
regular adjustment. To open or close the
menu, press the [MENU] key. You can select
items and options from the menu with the
omnipad. The complete menu appears on
page v.
1. Press the [MENU] key to display the main
menu.
SSel by omnipad & press ENT.S
RINGS EBL
OFFSET
SHIFT ZOOM
MODE DISP
DATA ECHO
TRAIL ECHO
STRTCH
ARP-10
MENU
OTHER
MENU Change brill
from 3 to max.
Figure 3-1 Main menu
2. Press the omnipad to select item. For
example, select RINGS. A message ap-
pears at the bottom of the menu window.
3. Press the [ACQ/ENTER] key to select set-
ting. Each time this key is pressed,
the message changes. For the RINGS
menu, the message sequence is as
shown below.
Change brill from Off to 1.
Change brill from 1 to 2.
Change brill from 2 to 3.
Change brill from 3 to max.
Change brill from max to Off.
Figure 3-2 Messages for RINGS menu
4. Press the [MENU] key to close the menu.
3. MENU OPERATION