Fisher & Paykel RX256 - Manual (Page 24)

22
Ice and water
Caution!
To avoid personal injury or property damage, observe the following:
Do not put fingers, hands or any foreign objects into dispenser opening.
Do not use sharp objects to break ice.
Do not dispense ice directly into thin glass, fine china or delicate crystal.
Front Fill (select models)
The FRONT FILL button dispenses water when pressed, without using the dispenser pad.
To dispense water
Select water on the control panel (the green indicator light will turn on).
Place your container against the dispensing pad and press.
Release pressure to stop dispensing.
Or on select models:
Place container under dispensing nozzle.
Press FRONT FILL button.
To dispense cubed or crushed ice
Select either cubed or crushed ice on the control panel (the green indicator light will turn on).
Place your glass or container against the dispensing pad and press (for crushed ice hold your
container as close to the chute as possible).
Slowly remove your glass when you have enough ice.
To dispense water and ice at the same time (select models)
Select either cubed or crushed ice.
Place your container against the dispensing pad and press.
At the same time press FRONT FILL button to dispense water.
Slowly release the FRONT FILL button and remove your glass when you have enough ice.
Note:
The Ice Mode may not be changed while ice dispenser is in operation.
The dispenser will automatically lock if it is active for more than five minutes. See Dispenser Lock
(page 21) for unlocking information.
Once dispensing has stopped a small amount of water may be dispensed. This will be collected
by the drip tray. Large spills should be wiped dry.
Light
A light activates within the dispenser cavity at full power when dispensing ice or water with the
main dispenser pad.
Press the LIGHT button once to select the Auto Light function and the Auto Light indicator will
illuminate. This activates the dispenser light when the light sensor detects the light levels in the
room are low. On select models the level of this light is controlled by Auto Light Level Selection
(see page 15).
On select models press the LIGHT button again to turn the dispenser light on continuously. The
ON indicator light will illuminate.
Press the LIGHT button again to turn the dispenser light off.