Fisher & Paykel RX256 - Manual (Page 36)

34
Care and cleaning
Replacing light bulbs
WARNING!
Electric Shock Hazard
Disconnect power to refrigerator before replacing light bulb. After replacing
light bulb, reconnect power.
Failure to do so can result in death or injury to persons.
Caution!
To avoid personal injury or property damage, observe the following:
Allow light bulb to cool once refrigerator has been turned off.
Wear gloves when replacing light bulb.
Upper fresh food section
The upper fresh food light bulbs are located behind the front
panel. Reach behind the panel to remove the bulbs.
Lower fresh food section
1
Push up on bottom tabs on light cover. Rotate cover up and
release tabs.
2
Remove light bulb.
3
Replace bulb with appliance bulb no greater than 40 watts.
4
Insert top tabs of light cover into liner slots and snap bottom
tabs into liner slots.
Upper freezer section
1
Remove ice bin by lifting front of bin and pulling out.
2
Remove light shield by pressing the upper right side of the
shield and rotating downward.
3
Remove light bulb. Replace with appliance bulb no greater
than 40 watts.
4
Rotate the shield upward, press in slightly and snap into place.
5
Replace ice bin by sliding in until bin locks into place.
Lower freezer section
1
Pinch both sides of light cover to remove.
2
Remove light bulb. Replace with appliance bulb no greater
than 40 watts.
3
Pinch both sides of the light cover to snap into place.
Ice and water dispenser
1
Locate light bulb inside top edge of dispenser frame. Unscrew
to remove.
2
Replace light bulb with a 7-watt, 120 volt bulb.
Fig.21 Lights in upper
freezer section
Fig.20 Light in lower
fresh food section
Fig.22 Ice and water dispenser
Light Bulb
Location