Fortinet FortiLog-400 - Manual (Page 106)

106
05-16000-0082-20050115 Fortinet Inc.
CLI commands FortiLog CLI reference
set system
interface
<intf_str>
config
denyaccess
ping <return>
https <return>
ssh <return>
snmp <return>
http <return>
telnet <return>
wins <xxx.xxx.xxx.xxx>
<return>
macaddr
{xxx.xxx.xxx.xxx |
factorydefault} <return>
log {enable | disable}
<return>
mtu <mtu_integer>
<return>
speed <speed_str>
<return>
status {down | up}
<return>
secip <xxx.xxx.xxx.xxx>
(secondary interface ip)
<xxx.xxx.xxx.xxx>
(netmask of secondary
ip) <return>
secallowaccess
ping <return>
https <return>
ssh <return>
snmp <return>
http <return>
telnet <return>
secdenyaccess
ping <return>
https <return>
ssh <return>
snmp <return>
http <return>
telnet <return>
stp-passthrough
{enable | disable}
mode static ip <xxx.xxx.xxx.xxx>
(interface ip)
<xxx.xxx.xxx.xxx>
(ip netmask)
<return>
session_ttl
port
<port_num><return>
timeout <timeout_int>
default <default_val>
mainregpage
hide <return>
show <return>
Table 11: set system command architecture