Fortinet FortiLog-400 User Manual
Page 109
FortiLog CLI reference
CLI commands
FortiLog Administration Guide
05-16000-0082-20050115
109
set system interface config
stp_passthrough
set system interface <intf_str> config
mode static
Set the interface mode to static.
set system mainregpage hide
Hide main registration message.
set system session_ttl port
<port_num> timeout <timeout_int>
Set the session timeout maximum for the port.
set system session_ttl port
<port_num> default <default_val>
Set a default value for the session time for the port.
set system mainregpage show
Show main registration message.
set system opmode active
Set the FortiLog unit to active mode.
set system opmode passive
Set the FortiLog unit to passive mode.
set system option admintimeout
<timeout_integer>
Enter an idle timeout number in minutes. Idle Timeout controls the amount of
inactive time that the web-based manager waits before requiring the administrator to
log in again.
The default idle time out is 5 minutes. The maximum idle time out is 480 minutes
(8 hours).
• <timeout_integer> is the idle timeout number in minutes.
set system option authtimeout
<timeout_integer>
Enter an auth timeout number in minutes. Auth Timeout controls the amount of
inactive time that the FortiLog unit waits before requiring users to authenticate
again.
The default Auth Timeout is 15 minutes. The maximum Auth Timeout is 480 minutes
(8 hours).
• <timeout_integer> is auth timeout number in minutes.
set system option language
<language_str>
Enter a language for the web-based manager to use. You can choose English,
Simplified Chinese, Japanese, Korean, or Traditional Chinese.
• <language_str> is the language you choose.
set system option refresh {interval |
none}
Set system option refresh interval. Enter none to cancel refresh interval.
set system alert_table alert_severity
<severity_integer>
Set the monitor severity level for alert table.
0 = Emergency, 1 = Alert, 2 = Critical, 3 = Error, 4 = Warning.
The log levels will be up to but not higher than the value you set.
get system alert_table alert_period
<period_integer>
Set the length of time to keep unacknowledged alerts in number of days between 1
and 7.
set system route <number> dst
<ipaddress_str> <ipaddressmask_str>
Set the FortiLog system route destination IP address and IP address mask.
• <ipaddress_str> is the destination IP address.
• <ipaddressmask_str> is the IP address mask.
set system route <number> gw1
<xxx.xxx.xxx.xxx>
Set the FortiLog system route primary gateway IP address.
• <xxx.xxx.xxx.xxx> is the primary gateway IP address.
set system route <number> dev1
<intf_name>
Set the FortiLog system route primary device (FortiGate unit) interface name.
• <intf_name> is the primary device interface name.
set system route <number> gw2
<xxx.xxx.xxx.xxx>
Set the FortiLog system route secondary gateway IP address.
• <xxx.xxx.xxx.xxx> is the secondary gateway IP address.
set system route <number> dev2
<intf_name>
Set the FortiLog system route secondary device (FortiGate unit) interface name.
• <intf_name> is the secondary device interface name.
set system time manual date
<mm/dd/yyyy>
Set the system time by month, day, and year.
set system time manual clock
<hh:mm:ss>
Set the system time by hour, minute, and second.