Fortinet FortiLog-400 - Manual (Page 89)

FortiLog CLI reference Connecting to the CLI
FortiLog Administration Guide 05-16000-0082-20050115
89
10 Type the password for this administrator and press Enter.
The following prompt appears:
Welcome!
You have connected to the FortiLog CLI, and you can enter CLI commands.
Setting administrative access for SSH or Telnet
To configure the FortiLog unit to accept SSH or Telnet connections, you must set
administrative access to SSH or Telnet for the FortiLog interface to which your
management computer connects. To use the web-based manager to configure
FortiLog interfaces for SSH or Telnet access, see
“Admin” on page 46 .
To use the CLI to configure SSH or Telnet access
1 Connect and log into the CLI using the FortiLog console port and your terminal
emulation software.
2 Use the following command to configure an interface to accept SSH connections:
set system interface port1 config allowaccess ssh
3 Use the following command to configure an interface to accept Telnet connections:
set system interface port1 config allowaccess telnet
Note: Remember to press Enter at the end of command. As well, remember to type end and
press Enter to commit the changes to the FortiLog configuration.