Fisher LNS-W03 - Manual (Page 3)

LENS REPLACEMENT AND INSTALLATION PROCEDURE
1. Remove screws A (2 screws).
2. Pull down the lower lens cover while pushing
the part D, then remove it.
3. Remove screws B (2 screws).
4. Remove screws C (2 screws) and remove
upper lens cover.
1
A
Fig-1
Fig-2
● IN CASE OF MODEL WITHOUT LENS
Remove 2 screws and pull down the plate.
2
UPPER LENS COVER
LOWER LENS COVER
C
B
D
D
COVER PLATE
REMOVE THE LENS COVER. (See figure-1)
(At the step , insert the light-block sheet in
the same position as the removed cover plate
has been placed. Two screws are not used.)
4
REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-2)
LENS
MOTOR LEAD
CONNECTORS " K16A" and " K16B"
(D)
(D) (D)
(D)
B
A
LENS MOTOR
Fig-3
❋ Figure shown inside of the cabinet.
REMOVE THE LENS. (See figure-3.)
1. Disconnect the Lens Shift connector
“K16A” from circuit board.
2. Disconnect the Zoom and Focus con-
nector “K16B” from circuit board.
3. Loosen the A, B wire holder and
remove the lens motor lead.
4. Remove screws D (4 screws) which
fastens the lens and remove the lens.
● IN CASE OF MODEL WITH LENS
A
Perform the steps to for lens replacement and installation. 5 1
SCREWS
First set the lens at the center position with lens
shift adjustment.
(Type 1 Cabinet)
Disconnect the Lens Shift connector
("K16A") from circuit board. (See Fig. 3.)
-2-