Fisher LNS-W03 - Manual (Page 6)

INSTALL THE LENS. (See figure-5)
1. Remove protective caps(front and
back) on the lens.
2. Mount the lens on mounting bracket
of the main cabinet with 4 screws.
Use the screws included with the lens.
Use the driver included with the lens to
fasten the screws.
(After using, keep it for latter use.)
5
INSTALL THE LIGHT-BLOCK SHEET. (See figure-6) 6
Install the light-block sheet around the lens
as shown in the illustration. Use the sheet
included with the lens.
Make sure the part no. and mark (TOP and
BACK) on Light-Block Sheet and set them
properly.
LENS MOUNTING BRACKET
ATTACHED DRIVER
Fig-5
Fig-6 LIGHT-BLOCK SHEET
Type FB1
(Part No. 610 285 8211)
LEAD
HOLDER
CONNECTOR
"K96S"
Fig-4
DISCONNECT THE LENS SHIFT CONNECTORS. (See figure-4)
Disconnect the Lens Shift Connectors
("K96S" and "K96R") from circuit board.
4
CONNECTOR
"K96R"
-5-
ADJUST FOCUS
Adjust focus following Focus Adjustment on
page 6.