Furuno Color LCD Sounder FCV-620/585 - Manual (Page 11)

1. OPERATION
2
1.2 Power On/Off
1. Press the /BRILL key to turn on the
power.
The unit beeps, the startup screen appears,
and then the equipment checks the ROM
and RAM for proper operation. After the com-
pletion of the equipment check, the last-used
display appears.
Startup screen
2. To turn off the power, press the /BRILL
key more than three seconds.
The time remaining until power is turned off
is counted down on the screen.
Note1: If "ROM/RAM check error!" appears, try
to press any key except the
/BRILL key to
start operation. However, the equipment may
not work properly. Contact your dealer.
Note2: The first time you turn on the power (or
any time the power is applied after a memory
reset), the installation menu appears. See the
figure below.
When this occurs, press the MENU/ESC key
twice to close the menu.
Installation menu
1.3 Adjusting Display
Contrast and Brilliance
1. Press the /BRILL key momentarily to
show the contrast/brilliance adjustment win-
dow. (The FCV-585 does not have the con-
trast function.)
Contrast/brilliance adjustment window
2. To adjust brilliance, press the /BRILL key.
Continual pressing changes the brilliance
continuously (0
→ 1 → ... → 9 → 8 → ... → 0 →
1 → ...). “0” is the dimmest and “9” is the
brightest.
After selecting “Brill” by using
S or T , you
may also use W or X to adjust brilliance.
3. To adjust contrast, after selecting “Contrast"
by using S or T , use W or X (only for FCV-
620). “0” is the lowest and “9” is the highest.
4. Press the ENTER key to save the setting and
close the window.
Note: When the power is reapplied after turning
off the equipment with minimum brilliance, min-
imum brilliance will be set after the equipment
goes through its initial start up. (The start up
screen appears with the maximum brilliance.)
Adjust the brilliance as necessary.
1.4 Choosing a Display Mode
1. Rotate the MODE knob to open the mode
setting window, which is displayed for five
seconds.
Language : English
Depth Unit
Temp Unit
Speed Unit
Wind Unit
Distance Unit
Fish Size Unit
Demonstrate
S / T : Select
[ENTER] : Enter
[MENU] : Quit
Installation
Francais
Espanol
Deutsch
Italiano
Portugues
Dansk
Svenska
Norsk
Suomi ,
∼
English
W
Min Max
X
Contrast/Brill
Contrast 5
Brill 9
S / T : Select
[ENTER] : Set
[MENU] : Cancel
NAV1
LF-ZOOM
LF-DEEP
DUAL
HF-SHALLOW
HF-ZOOM
NAV2
MODE
Low frequency zoom mode*
Low frequency mode (50 k)
High frequency mode (200 k)
High frequency zoom mode**
Nav data mode 1
Nav data mode 2
Dual frequency mode
*: The indication at the top on the screen is
B/L-LF, B/Z-LF or M/Z-LF.
**: The indication at the top on the screen is
B/L-HF, B/Z-HF or M/Z-HF.
B/L: Bottom lock, LF: Low frequency,
B/Z: Bottom zoom, HF: High frequency,
M/Z: Marker zoom