Furuno Color LCD Sounder FCV-620/585 - Manual (Page 23)

1. OPERATION
14
3. Press the MARK or ENTER key to register
the position set at step 2.
A red vertical line appears on the position set
at step 2. The waypoint is named automati-
cally with the next sequential waypoint
number. If you want to change waypoint
name, go to step 4. Otherwise, go to step 6.
Waypoint setting window
Note1: When TLL or FURUNO-TLL is selected
at TLL Output on the NMEA menu of the System
menu, the latitude and longitude position at the
cursor position is output to the navigator.
Note2: If you attempt to enter 21st waypoint, the
message "Already entered 20 waypoints. No
more waypoint can be entered." appears. In this
case, erase an unwanted waypoint to enable
entry. See paragraph 1.18.3 for details.
4. Press the ENTER key to to open the way-
point name entry box.
Waypoint name entry box
5. Enter the waypoint name (Max. 8 charac-
ters).
a) Use
S or T to set character. When
pressing S , character order is 0 → 1 → ...
→ 9 → - → A → ... → Z → _ → 0 → ....
When pressing T , character order is
reverse.
b) Use X to shift cursor.
c) Repeat step a) and b) to set the name
desired and press the ENTER key.
6. Press the MENU/ESC key to close the
window.
Registering a waypoint by L/L
1. Press the MENU/ESC key to open the menu.
2. Use
S or T to choose Data and press the
ENTER key.
Data menu
3. Use S or T to choose WPT List and press
the ENTER key.
WPT List window
4. Use S or T to choose an empty waypoint
and press the ENTER key.
The Waypoint setting window appears. Lat
and Lon indicate the current position.
5. Use S or T to choose item desired and
press the ENTER key.
The character setting box is shown.
For L/L For waypoint name
6. Enter latitude and longitude, similar to how
you entered the waypoint name.
7. Press the MENU/ESC key four times to close
the window.
New Waypoint
Name : 01
Lat : 34 ° 22.796'N
Lon : 136
°
07.264'E
Erase?
S / T : Select
[ENTER] : Enter
[MENU] : Quit
01
S
T
Data
S
/
T
/
W
/
X
: Select
[ENTER] : Enter
[MENU] : Back
Go to WPT* : Off
WPT List*
Data Box 1 : Off
Data Box 2 : Off
Bearing : True
Wind Spd/Dir : True
Trip Source : Own
Temp Source : Own
Speed Source : Own
Trip Reset
Odo Reset
*: Go to WPT
and WPT
List are
inoperative
when no
latitude and
longitude
position is
input to the
12-24 VDC/
NMEA port.
WPT List
S / T : Select
[ENTER] : Enter
[MENU] : Quit
01
S
S
34
°
22.796'N
S
S
S
S
02