Franke Consumer Products FFPD100 - Manual (Page 4)

4
ENGLISH
4. Install the mounting hardware (G R0338031) to the threaded shank in the following
sequence:
1 - round flat fiber washer
2 - triangular shaped plastic support
3 - flat metal washer
4 - thread brass nut
5. Assure that the handle and spout are properly aligned in forward position
6. Tighten the brass nut (4) with the provided wrench or use other professional tools.
7. Connect the supply flexible hoses to the supply net, interposing between-them the
non-return valve with the gaskets as indicated in the figure.
NOTE:
solid surface installation: The sub-countertop mounting surface
needs to be flat and free of debris; otherwise the faucet will not
sit properly.
Tile installation: Avoid installations near or on top of grout lines.
The faucet will not sit secure when sitting on such.
2. Remove all mounting hardware from protecting plastic bag.
3. Place the large O-ring over the faucet shank and place the faucet into the desired
location.
NOTE:
the rubber O-ring should be sitting on top of the countertop and between the faucet
body. DO NOT use putty or other sealant at this location
11
3
4
2
21 mm [13/16”] key