Franke Consumer Products FFPD100 - Manual (Page 5)

5
ENGLISH
8. Flush out debris from water lines and faucet.
1. Pull spray hose out of the faucet spout and point the open end towards the
sink drain.
2. Open faucet handle - cold side first - by turning handle to the right and mov-
ing it upward.
3. Let the faucet run on cold for 15 to 30 seconds.
4. Open faucet handle - hot side second - by turning handle to the left and mov-
ing it upward.
5. Let the faucet run on cold for 15 to 30 seconds.
6. Turn faucet off.
7. Test for leaks under the cabinet.
7. The body can be fixed both onto the wall and on surface: .
1. Screw the fixing rail onto the single lever body.
2. Insert it completely in the given plate.
3. Place the single lever body into the sink hole made at a certain distance from
the wall.
4. Place the plate properly where it has to be fixed, making sure the drilling
points on the wall are well marked corresponding to the two holes with a 28
mm [1-1/8”] interaxe.
5. Place the dowels in the holes.
6. Fix the plate onto the wall with the given screws.
7. give stability to the position of the single lever by acting on the fixing rail
and block the movement with the given nut.
A
over the sink under the sink
B