Furuno PG-1000 - Manual (Page 15)

8
2 CORRECTING MAGNETIC
ANOMALIES
2.1 Controls and Indications
AUTO TRUE CALIB STATUS
PG-1000 INTEGRATED HEADING SENSOR
AUTO TRUE
CALIBRATION
On: Auto correction is on.
Off: Auto correction is off.
On: True heading is output.
Off: Magnetic heading is output.
Off: Normal
Blinking: Correcting
the deviation.
(On installing.)
On: Normal
Off: Error
Corrects the heading.
Selects output data format; magnetic or true
Turns on and off deviation corrections.
Figure 18 Front panel of PG-1000
2.2 Turning the Power On/Off
Note: You may leave port after the STATUS
LED begins lighting (not blinking).
Power to the sensor unit may be turned on or
off at the mains switchboard.
1. Turn the mains switch on.
STATUS LED blinks. About two minutes
later it lights. Bearing is now reliable.
;;
;;
AUTO TRUE CALIB STATUS
About two minutes later
AUTO TRUE CALIB STATUS
;
;
: On
: Blinking
: Status depends on settings
: Off
error
normal
Figure 19 LED state at power on