FilterStream V2100 - Manual (Page 13)

13
M A I N T E N A N C E / F I L T E R R E P L A C E M E N T
hand by grasping the pull-tab on top of the
Pre-Filter with your fingers. Empty any dirt,
debris, or liquid from the Bowl and Pre-Filter
into the sink or wastebasket.
(c) Rinse or hand wash the Pre-Filter, Bowl and
Filter Cover with water (if needed, with warm,
soapy water).
Note: The Pre-Filter, Bowl and Filter Cover can
be washed in the dishwasher (top rack only).
(d) Allow the Pre-Filter, Bowl and Filter Cover to
dry. Then reinsert the Pre-Filter into the Bowl,
snap the Filter Cover onto the Handle/Housing,
and reattach the Bowl to the Handle/Housing.
C L E A N I N G / R E P L A C I N G F O A M
A N D H E P A F I L T E R S
To remove/replace the Filter (either foam or HEPA)
from the vacuum, please
follow these steps:
(a) Remove the Filter
Cover from the vacuum
Handle/Housing.
(b) Remove the Filter from
the Handle/Housing.
(c) Clean the Filter as
follows.
Foam Filter Cleaning:
Wash the Foam Filter in
warm, soapy water until clean. Allow the Foam
Filter to dry before reinserting into the
Handle/Housing.
Note: Use only mild soap. Avoid detergents,
chemical cleaners or solvents as these may
damage the plastic.
HEPA Filter Cleaning: Use your finger to lightly
clean the paper surface of the HEPA Filter,
clearing off any dirt, dust, and hair.
NOTE 1: Do not wash the HEPA Filter. Water
will permanently damage the filter.
NOTE 2: Under normal household use, the
HEPA Filter will last over one (1) year.
a
b